1. Measure and Mark
   Measure the required size and mark the cutting line on the back side of the panel.
2. Secure the Panel
   Place the panel on a flat and stable work surface to prevent movement during cutting.
3. Score the Cutting Line Multiple Times
   Use a straight edge as a cutting guide and make multiple passes along the marked line with a utility knife. Do not force the blade through the panel in a single cut.
4. Separate the Panel
   Gently bend the panel along the cutting line to separate the material.
5. Adjust the Edge
   Check the cut edge and use the utility knife for minor adjustments if needed.

• Use a sharp blade for cleaner cuts.
• Multiple light passes provide better control and accuracy.
• Keep the cutting line straight to ensure proper installation alignment.

1. Measure and Mark
   Measure the required dimension and mark the cutting line on the back side of the panel.
2. Secure the Panel
   Make sure the panel is properly supported and stable before cutting.
3. Cut Along the Marked Line
   Guide the circular saw slowly along the marked cutting line while maintaining a steady cutting direction.
4. Check the Cut Edge
   After cutting, inspect the edge and remove any dust or debris before installation.

• Keep the tool stable during cutting.
• Avoid excessive pressure to prevent surface damage.
• Confirm measurements before cutting to avoid unnecessary adjustments.

▶ Use a jigsaw or another appropriate cutting tool.

1. Mark the required shape on the back of the panel.
2. Confirm the measurements and installation position.
3. Cut slowly along the marked line.
4. Test-fit the panel in the installation area.
5. Trim the edges as needed.